Broken Oil Dipstick tube
#1
Broken Oil Dipstick tube
I was removing my old restricted headers to put in some pype's headers. While removing the stock headers on the side of the dipstick tube, my dipstick tube broke. So now i am left with a short amount of tube stuck where the dipstick tube should be in and it is preventing me from installing a new dipstick tube.
The only solution i see is lifting my motor a few inches and removing my oil pan and taking out the broken piece of dipstick tube with my hand. But removing my oil pan is a lot of work. Has anybody ever experienced this, is there a simpler solution in removing the broken piece of dipstick.
Any suggestions would be appreciated. Thanks
The only solution i see is lifting my motor a few inches and removing my oil pan and taking out the broken piece of dipstick tube with my hand. But removing my oil pan is a lot of work. Has anybody ever experienced this, is there a simpler solution in removing the broken piece of dipstick.
Any suggestions would be appreciated. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
daltron
5.0L GT S550 Tech
17
04-28-2016 08:10 PM
MustangForums Editor
General Tech
0
09-25-2015 06:58 PM