5.0L (1979-1995) MustangTechnical discussions on 5.0 Liter Mustangs within. This does not include the 5.0 from the 2011 Mustang GT. That information is in the 2005-1011 section.
Sponsored by Weld Racing
Welcome to Mustang Forums!
Welcome to Mustang Forums.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
dont know about the fly wheel but the pressure plate bolts are 35 ft lbs
87 coupe.96 explorer block.stock bottom end.gt40 heads.trickflow stage 1 cam.edelbrock air gap intake and 600 edelbrock carb.mallory distributor.5 speed with 3.27 gears.mac shorties with flowmaster 40 series
I use a 3/8" impact on the on the flywheel bolts, which is about 75lbs on my gun. The pressure plate, I just torque them down evenly. and go over them a few times to make sure they are all the same. I probably go 20 to 25 lbs. Never had a problem.
This forum is owned and operated by Internet Brands, Inc., a Delaware
corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford
Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor