Gasket Matching
#1
Gasket Matching
For those of you that gasket match -
Do you also match the coolant ports as well? Mine are slightly interfering by maybe 1/8". My intake ports are all matched, didn't know if the coolant ports need it as well
Do you also match the coolant ports as well? Mine are slightly interfering by maybe 1/8". My intake ports are all matched, didn't know if the coolant ports need it as well
#5
Not over heating this big *** stroker lol. No but really, I just didn't want it to act as a blockage and have this thing over heat. That was the main concern. I didn't end up doing it, there wasn't that much interference once I got everything lined up.
#6
Yea I don't know why but every intake gasket set I have ever installed never line up with the cooling ports on the heads.
I don't think it would have hurt to shave that little bit off , because I always am pretty generous with the ultra black around those any ways. I have just never bothered with them because it doesn't seem like that little bit would interfere that much with cooling the lower intake.
I don't think it would have hurt to shave that little bit off , because I always am pretty generous with the ultra black around those any ways. I have just never bothered with them because it doesn't seem like that little bit would interfere that much with cooling the lower intake.
Thread
Thread Starter
Forum
Replies
Last Post
AmericanMuscle4.6GT
2005-2014 Mustangs
7
11-10-2015 02:06 PM