dchallenger

found out that i have windsor heads on my 1990 foxbody...how do i know if the block is a windsor as well...behind the starter i saw oF2 stamped ...also 27 oa e1tes also stamped...please help

Duncan_GT

Post a picture of the front of the engine

Or pull the lower intake and you'll see "351" stamped in the lifter valley.

I'm going to take a stab and say it's not though

dchallenger

Duncan_GT

Take a picture right in front of the engine. I need to see where the timing cover is in relation to the head

aode08

look for 351w swap components, the intake is wider, you need special headers,special bracket for power steering and alternator.What color are the fuel injectors? are they orange caps?

dchallenger

injectors are blue...headers was aftermarket long tube...intake manifold was the edelbrock...

dchallenger

duaner

easiest way is look at bolts on fuel pump. one on each side is Windsor. one top and one bottom is Cleveland.

Duncan_GT

There is a difference in valve cover bolt pattern between Cleveland and Windsors, you'll have to google it. If you have the trans out of the way, you can measure the #5 crank journal. 2.75" is Cleveland, 3" is Windsor. Smaller than the Cleveland and you have a 302, 2.2xx" I believe.

I need to see where the water jackets are in the front of the block. If you could try and get a picture of the passenger side head where the timing cover is. That's going to be the easiest way to tell, but with the accessories on its hard to see

dchallenger