Roller rockers
#1
Roller rockers
Is there a roller rocker that will bolt on in place of my stock rocker arms?
and if so which is the best bang for the buck?
89 302 stock evrything except cam and headers....dunno which cam.
I can just hear it
and if so which is the best bang for the buck?
89 302 stock evrything except cam and headers....dunno which cam.
I can just hear it
#2
the heads have to go,guides and studs have to be put in.also, the change would do nothing with the e7s
#3
You're looking for pedestal mount roller rockers. Crane Cobra's are relatively cheap, but they will increase the ratio from 1.6 to 1.7, which depending on your cam can be a good thing, or a bad thing. I used a set of those for 10+ years with the factory pistons, factory cam, factory heads, and then later with TF TW heads and a 2031 Crane cam.
#4
OK UPDATE, mystery cam is a compucam 2040. whereas I have read that its pretty much the same as a e303. can I use 1.7 rockers and not have clearance issues?
would I continue to use the pushrods that are in it now?
one other question is interference...If my motor where to jump time could my valves hit my pistons? is this a "non interference motor"
would I continue to use the pushrods that are in it now?
one other question is interference...If my motor where to jump time could my valves hit my pistons? is this a "non interference motor"
Thread
Thread Starter
Forum
Replies
Last Post
69MustangCoupe393cid
Archive - Parts For Sale
2
10-03-2015 10:33 AM
JDWalton
4.6L V8 Technical Discussions
8
09-24-2015 08:47 PM