-   5.0L (1979-1995) Mustang (
-   -   Autometer water temp gauge install (

robotnix 07-17-2014 09:54 PM

Autometer water temp gauge install
Got myself one of those, digital version.

Do i tap into the same wire that is used by the temp sender on the intake? So i cut that wire, connect a second one for the second gauge i guess!

Js88lx 07-18-2014 03:59 AM

use the instructions from

Js88lx 07-18-2014 04:00 AM

dawson1112 07-18-2014 05:10 AM

I would not use the stock sending unit for this, the auto meter gauge should have been provided with a sender. If you want to keep your stock gauge in working order , then get a thermostat housing with a tapped hole for a sending unit similar to this

Im not a big fan of having 2 gauges reading off the same sending unit .

Boss_Hotrod 07-18-2014 07:22 AM

I took my stock sender out and used that hole. Also if you want to keep that gauge working you can remove the upper intake and look on the lower towards the left rear and youll see a pipe plug. Take that out and it goes into a water jacket. There is also one on the right side but the EGR coolant line plugs into that one. You can remove that setup if your EGR is deleted.

All times are GMT -5. The time now is 02:13 AM.