AC blows cold but not strong
#1
AC blows cold but not strong
My air conditioner just recharged blows nice and cold however does not blow strong I did some research and found out of there is not a cabin air filter in the 94 model GT. My question is how in the world would I get in there to clean the squirrel cage fan? I am assuming it has some dust buildup on it limiting them out of there that it can move. It gets Mighty hot in here.
#2
My air conditioner just recharged blows nice and cold however does not blow strong I did some research and found out of there is not a cabin air filter in the 94 model GT. My question is how in the world would I get in there to clean the squirrel cage fan? I am assuming it has some dust buildup on it limiting them out of there that it can move. It gets Mighty hot in here.
When you take it out, make sure the blower wheel itself is in not cracked or spinning freely on the motor shaft. That's usually what happens. The plastic wheel gets rounded out then no longer spins with the motor so you have decreased air flow.
Also, the blow motor speed resistor may not have all speeds available (burnt out) so even though you put it to 2, 3, or 4 you might only be getting speed 1 and/or 2.
#3
How To Install Replace Squeaking Groaning AC Heater Fan Ford Mustang 94-04 1AAuto.com - YouTube
When you take it out, make sure the blower wheel itself is in not cracked or spinning freely on the motor shaft. That's usually what happens. The plastic wheel gets rounded out then no longer spins with the motor so you have decreased air flow.
Also, the blow motor speed resistor may not have all speeds available (burnt out) so even though you put it to 2, 3, or 4 you might only be getting speed 1 and/or 2.
When you take it out, make sure the blower wheel itself is in not cracked or spinning freely on the motor shaft. That's usually what happens. The plastic wheel gets rounded out then no longer spins with the motor so you have decreased air flow.
Also, the blow motor speed resistor may not have all speeds available (burnt out) so even though you put it to 2, 3, or 4 you might only be getting speed 1 and/or 2.
#5
Last edited by jdthedj10; 07-30-2016 at 01:20 PM. Reason: Added pic
#6
Thread
Thread Starter
Forum
Replies
Last Post
injentechnology
S550 2015-2023 Mustang
14
08-28-2016 06:16 PM
dlee
4.6L (1996-2004 Modular) Mustang
7
07-14-2016 03:31 PM