mini tubs+roll cage help
#1
mini tubs+roll cage help
Hey guys, just looking for some ideas on how/were to run my back bars to with mini tubs installed (takes up mos of the frame area) just looking for ideas on what people have done, AND what is legal. Had a couple ideas but wana see if there was something different
and as a side note, its a 92 hatch with wolf craft mini tubs, have the 10 point already installed, (no back bars) have the tubing necessary to make back bars, was going to try and run some sort of straight back system with an x in the middle for added strength.
I was also looking at tying in the strut bar mount that is right above the rear axle area to the back part of the cage for a little added strength.
and as a side note, its a 92 hatch with wolf craft mini tubs, have the 10 point already installed, (no back bars) have the tubing necessary to make back bars, was going to try and run some sort of straight back system with an x in the middle for added strength.
I was also looking at tying in the strut bar mount that is right above the rear axle area to the back part of the cage for a little added strength.
Thread
Thread Starter
Forum
Replies
Last Post
mungodrums
S550 2015-2023 Mustang
7
09-29-2015 09:18 PM
MustangForums Editor
Street/Strip
5
09-08-2015 06:25 PM