Originally Posted by mjr46
you should be measuring for push rods, no assuming stock length will work, all cams base circles are not the same and if using aluminum heads and gasket thickness will all affect length needed. Not sure what head you'll be using but if it's aluminum, never once has a stock length worked for me, and getting the narrowest witness mark is what you're after, not necessarily the "center" it on the valve stem
That's what I would have figured as well. I took a pic of the marks after I bolted the head on using a solid roller (converted), those rods and my comp rockers. I'll try to dig it up.
Car has been running great. Was datalogging more today just playing with the idle after getting my tstat and new cap on. Also had to wire in a fan controller since the prev owner hard wired it to ign.
Finally got all my gauges in Binary Editor to start reading after going back over my data log payloads.
Idle still surging a bit. Hope to take it out tomorrow after new clutch cable and get some good logs and more miles on new engine.