will this work?
09-10-2013, 04:02 PM
#1
4th Gear Member
Thread Starter
Join Date: May 2012
Location: New York
Posts: 1,220
will this work?
im ordering SLP axle backs for my 2011 gt and i would like to know if it will fit with JPC over axle pipes so i can delete the factory kinks and resonators.
Down the road (after winter storage) i will be getting kooks longtubes and catted x pipe and im thinking it should all piece together, but for now would these work together?
http://www.jpcracing.com/2011-up-mus...steel-revised/
this is the pipes im talking about, just hoping the slps and this will bolt together to make a cat back, thoughts..?
Down the road (after winter storage) i will be getting kooks longtubes and catted x pipe and im thinking it should all piece together, but for now would these work together?
http://www.jpcracing.com/2011-up-mus...steel-revised/
this is the pipes im talking about, just hoping the slps and this will bolt together to make a cat back, thoughts..?
Thread
Thread Starter
Forum
Replies
Last Post