You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I used a breaker bar, with a set of 9mm-20mm, ratcheting wrenches from 7/16"-3/4", and deep sockets from 1/2"-3/4". I can let you know the exact sizes i used in a few.
Upper control arm: 18mm on the breaker bar and a 3/4 wrench,
lower control arm: 13/16 on the breaker bar and 3/4 wrench,
shock: 3/4 on breaker bar and 5/8 wrench,
and you cant forget a jack and jack stands
__________________
PERFORMANCE MODS:
Mac Long Tube Headers, Mac O/R H pipe, Flow 40's, SPEC Stage 2 clutch VISUAL MODS:
01 Cobra Front w/mach 1 chin spoiler, 10th Anniversary 17" Cobra Rims, eibach lowering kit, 6k hid headlights TO COME:
Built rear end, GT rear bumper, Saleen wing, Bilstein shock & struts, front coil-over kit, mm 4 bolt c/c plates
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company
junkyard run/ rear end removal
I knew I was leaving something out
