Also it is best not to use gasket maker to seal the upper and lower intake manifolds. When compressed it will squeeze into the intake runners and affect flow. Get a gasket from the parts house. Although i have had to get a block of wood and pry between the valve cover and upper intake on the drivers side to remove one that was done with gasket maker.
__________________
1991 GT with GT-40P heads, Polished typhoon upper and lower, E-cam, 1.6 rr's, Trick flow valve springs, BBK shorties, 70mm TB and EGR,70mm mass air, 190lph pump, BBK regulator (42psi) MSD wires and coil.
|