Drivers window regulator problem
#1
Drivers window regulator problem
Hi, I have a 66 fastback. I took the drivers side window scissors assy, and regulator out, cleaned and lubricated them, replaced the bushings and clips with new, and reassembled.
Now, when I roll down the window, when it gets about half way down, the scissors bind with the rod that goes from the inside handle to the door latch, springing the latch and opening the door. I thought I put it together the same way I took it apart, but something has changed.
Any ideas as to why the rod is binding with the scissors?
Thanks.
Now, when I roll down the window, when it gets about half way down, the scissors bind with the rod that goes from the inside handle to the door latch, springing the latch and opening the door. I thought I put it together the same way I took it apart, but something has changed.
Any ideas as to why the rod is binding with the scissors?
Thanks.
#2
Any ideas as to why the rod is binding with the scissors?
...not really as smart-alecky as I sound.
maybe take the passenger side door panel off and have a look in there to see if you can figure out what went wrong.
.
#4
window regulator
Be careful to note the position of the rod that connects the inner door handle to the latch. I had this in the wrong position and the door wouldn't latch when the window is down.
Good luck!
#5
You must have bent the rod between the handle and the latch. I just put my windows in last week and I know there should be clearance between the rod and the scissor. Did you remove the inner latch release and rod when doing this?
Thread
Thread Starter
Forum
Replies
Last Post
HorsePower99
4.6L (1996-2004 Modular) Mustang
1
08-26-2015 11:29 PM