removing starter?? 97 GT
12-11-2005, 01:43 AM
#2
5th Gear Member
Join Date: Jul 2004
Location: Pittsburgh/Dayton
Posts: 3,062
RE: removing starter?? 97 GT
Its a huge pain in the ***...i just had mine out thursday when i put a new clutch in. Use swivels and position your hand in hte most awkward angle going straight up and then down haha...
I didnt even put the 3rd starter bolt back in...
I didnt even put the 3rd starter bolt back in...
12-11-2005, 03:01 AM
#4
5th Gear Member
Join Date: Jul 2004
Location: Pittsburgh/Dayton
Posts: 3,062
RE: removing starter?? 97 GT
I think I used 2; What i did was get the actual socket on the nut by itself. then just pieced suff together from there trying stuff to beable to get to where i could get a wrench on it.
12-11-2005, 08:02 PM
#7
3rd Gear Member
Thread Starter
Join Date: Oct 2005
Location: San Marcos, TX
Posts: 916
RE: removing starter?? 97 GT
well i got it...i just pretty much used all my weight, and one of the dowels in the swivels broke, lol. at the same time it loosened the bolt up a little. so i got a small 1/4 drive ratchet and somehow got it up in there and just turned it about a mm at a time. it will be alright if i dont put that one back on right?
12-11-2005, 08:05 PM
#8
5th Gear Member
Join Date: Jul 2004
Location: Pittsburgh/Dayton
Posts: 3,062
RE: removing starter?? 97 GT
ORIGINAL: jmmorgan82
well i got it...i just pretty much used all my weight, and one of the dowels in the swivels broke, lol. at the same time it loosened the bolt up a little. so i got a small 1/4 drive ratchet and somehow got it up in there and just turned it about a mm at a time. it will be alright if i dont put that one back on right?
well i got it...i just pretty much used all my weight, and one of the dowels in the swivels broke, lol. at the same time it loosened the bolt up a little. so i got a small 1/4 drive ratchet and somehow got it up in there and just turned it about a mm at a time. it will be alright if i dont put that one back on right?
I think so, I put mine back in; but just tightened it with my hand...i figure if it falls out whatever; I dont think it will hurt anything.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
logan409
4.6L (1996-2004 Modular) Mustang
10
09-26-2015 07:43 PM
