2006 GT 5spd will not come off Motor!
#1
2006 GT 5spd will not come off Motor!
Ok, all 9 bolts are out, Starter out, driveshaft off, shifter out, hydraulic line off, sitting on transmission jack and this trans will not come off.
I shook it, tapped it a few times with a hammer but not too hard, grabbed a pry bar and lightly tried that and won't budge.
Did I forget something???
I shook it, tapped it a few times with a hammer but not too hard, grabbed a pry bar and lightly tried that and won't budge.
Did I forget something???
#2
Sometimes they're stuck on there pretty good. When I took mine off I left the hydraulic line on and pushed the clutch in a few times and that helped separate the two a little. Then I was able to gently pry it the rest of the way.
#3
It can be difficult for it to separate along the dowel pins. Some powerblaster will help break loose any grime or rust. But eventually, using a pry between the engine and trans will be needed. had one like that earlier this year. Eventually separated it.
Thread
Thread Starter
Forum
Replies
Last Post
BeatnikFink
New Member Area
6
10-01-2015 08:00 PM
logan409
4.6L (1996-2004 Modular) Mustang
10
09-26-2015 07:43 PM