Anybody ever change rod bearing with the engine in the car
#1
Anybody ever change rod bearing with the engine in the car
Looks like i may have hammered her a little bit to hard, got a ticking in number six cylinder, goes away if i pull the plug wire, starts ticking around 2K RPM and higher. I thinking its a rod bearing
I figure i will drop the pan and pull the rod cap and measure the crank just for the fun of it. Searched the forum but couldn't find anything on this subject
Anybody ever successfully accomplish this?
I figure i will drop the pan and pull the rod cap and measure the crank just for the fun of it. Searched the forum but couldn't find anything on this subject
Anybody ever successfully accomplish this?
#6
I did replace all eight, i was going to pull the mains but decided not to based on i plan on pulling the motor and trans in the fall and do a complete rebuild. i just want to drive it for the summer so i thought i would take the chance. i have other pics if anyone is interested i did plastagage all the rod journals and all were within spec. FYI i got the connecting rod bolts from FORD $2.50 ea. which i though wasn't too bad
Thread
Thread Starter
Forum
Replies
Last Post
Jskeezy84
4.6L General Discussion
5
09-08-2015 01:40 AM
92 5.0stang
5.0L (1979-1995) Mustang
4
08-13-2015 06:46 AM
Milan Dragway
Members Rides and Car Show Section
0
08-12-2015 03:43 PM