This is my project for the day.
#1
This is my project for the day.
So I finally got a chance to get under the 00 gt , I knew I was going to have to replace the exhaust on it so I just went ahead and ordered a whole new system from summit, new down pipes new mid new intermediate and new mufflers. Luckily the over axle and tail pipes are in pretty good shape yet so Im reusing those. I have all my stuff in boxes a day after ordering from summit, I love those guys they get it to my house over night almost every time.
This is what the previous owner calls " Needs mufflers but all the piping is there "
Get the saws all out Im taking it apart .
This is what the previous owner calls " Needs mufflers but all the piping is there "
Get the saws all out Im taking it apart .
#2
Oh and I figured out my speedometer issue and why it wasn't working, sensor unplugged,,,but that's not all folks, its a 96-98 T45 with the speedo gear plugged it in and I get 8 mph at about 65.. It should be a OSS instead of a VSS , but thanks to the guys at Dallas Mustang , I should resolve the speedo issue by Monday. Ordered the speedcal and they assured me I could calibrate that discrepancy out of it and my speedo would be accurate and my cruise will work again.
#4
lol I take it that didn't ride like a caddilac, and aren't those things supposed to be used to compress the spring lol?
#5
My firebird with cut springs rode better. Definitely not how a grand marquis should be. Hell, it's not even that, just a couple of bolts with nuts and whatever the hell those end pieces were. Took me a good two hours to undo that crap.
#8
Ya know surprisingly the engine runs smooth as silk with no kinds of rattles or noises , it runs just as good as my 05 Lincoln towncar with less than 100k miles on it. Same exact engine with the exception of the mustangs stock power adders. It was missing a bit as it warmed up , I believe it was due to not having the up stream 02 sensors hooked up , so after it got fully warm it reverted to a default air/fuel and ran good.
I got side tracked from the exhaust and decided to check the calipers out because they were hanging up and dragging. The car sat for who knows how many years . Sure enough both calipers had a piston that was froze up , couldn't even budge it with a clamp, so 2 new calipers today and installed as well as bled.
I knew I was going to sink a little money into getting it running good and sounding good, but for the 2800 I paid for it and the 1k I have put in tires exhaust and brakes I still think I got it for a good deal.
I got side tracked from the exhaust and decided to check the calipers out because they were hanging up and dragging. The car sat for who knows how many years . Sure enough both calipers had a piston that was froze up , couldn't even budge it with a clamp, so 2 new calipers today and installed as well as bled.
I knew I was going to sink a little money into getting it running good and sounding good, but for the 2800 I paid for it and the 1k I have put in tires exhaust and brakes I still think I got it for a good deal.
#10
The only expense I didn't have planned was the $109.00 for the speedcal to adjust for the 98 transmission that was put in it.
After that is taken care of I just need to track down why the fuel gauge only reads empty all the time. It sweeps correct during a gauge test , so I assume it has a short someplace, or is open. Im not to familiar yet with how that gauge system works. I will know soon enough I assume they didn't get something put back together right when they changed the fuel pump.