AdvancedSpecV

Wow, you guys are awesome! Cary is waaaay closer, lol.

I've already sent him a PM, so I'm just waiting for a response. To be honest I've had the funds to do this for like 3 months but I hate spending money (you should've seen me after I bought the Stang, lol), I just finally decided to pull the trigger. If caster/camber plates are a better decision I'm ok with going that route. I just didn't know if that would be overkill or not. Either way I really only want to do it once and the right way.

hwm3

If you can swing it an 18v cordless impact is the way to go. I've got a SnapOn and it's got plenty of power for any bolt on the Mustang and is small enough to fit where a 110v won't. The only down side is they are pricey. I got lucky and did some trading with a friend that drives a SnapOn truck.

Sleeper_GT

I bought a battery one....Doesn't do so well. What did you pay for the SnapOn...I may be looking to upgrade.

hwm3

I got this one. The other cordless impacts don't come close.

http://buy1.snapon.com/catalog/item....re&dir=catalog

Paid half that though.

Sleeper_GT

Yep....that will cost you..........

clowe1965

do I want car insurance or that tool.....holy crap that's expensive. I'll stick with a cord. it nearly didn't do the trick on a few bolts on the jeep, and its a 1/2 drive.

Sleeper_GT

Just ordered a 3D Carbon GT500 Spoiler..pre-painted DIB....Or as Crint would say....DUB...LOL

EDIT: Also ordered the whiteline trans bushing

Jeffk

I need to roll my rear fenders. Even with the wheel gap I have when I take off camber driveways and stuff the tires are rubbing.

Allupinya

Ordered 8 sets of Weld wheels and a bunch of 3dcarbon parts, you guys should see!

Sleeper_GT

I can't wait to see.....