Boss 9 (557) project finished (pics)
#23
#25
The air claener base was custom made to fit level with the hood. The air cleaner did seal up to the scoop for a ram air isolated fit. I think you could do the same thing by using a larger base with a smaller filter and having a rubber seal that fits on the outer part of the base.
I sold the car on ebay shortly after building. That owner sold it at Barrett Jackson in Florida. The new owner has taken it to Mecum 3 times without selling. It went to 120,000 in Dallas.
I am building another one but using TCI front end this time and Detroit speed rear suspension. Same engine but a beefed up 5 speed. Also using an under dash braking master cylinder to clean up engine compartment. Hopefully it will be done next year. These cars cost $$$$$$$. Unfortunately.
I sold the car on ebay shortly after building. That owner sold it at Barrett Jackson in Florida. The new owner has taken it to Mecum 3 times without selling. It went to 120,000 in Dallas.
I am building another one but using TCI front end this time and Detroit speed rear suspension. Same engine but a beefed up 5 speed. Also using an under dash braking master cylinder to clean up engine compartment. Hopefully it will be done next year. These cars cost $$$$$$$. Unfortunately.
#27
hey guys... seeing the interest here.... I thought I'd share my BOSS 529 build. Here's the link to my build site. http://www.fordmuscle.com/category/f...tang-boss-429/
pls note I have 3 pages so far of build threads
Comments/feedback welcome.
Thanks Mark
pls note I have 3 pages so far of build threads
Comments/feedback welcome.
Thanks Mark
Thread
Thread Starter
Forum
Replies
Last Post
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM