I need a 5/32 tap
10-25-2006, 02:26 AM
#13
5th Gear Member
Join Date: Jun 2006
Location:
Posts: 4,089
RE: I need a 5/32 tap
I feel left out here...
ORIGINAL: MustangPammie
Got a 10-24 tap. Brought the screw to yet another hardware store (one in a small town where they are very helpful) and he measured, checked, and said this was what I needed. $3 is a lot better than $450, huh?
Thank you very, very much, NC Harley. If you're over 21, I can reward you ...
Got a 10-24 tap. Brought the screw to yet another hardware store (one in a small town where they are very helpful) and he measured, checked, and said this was what I needed. $3 is a lot better than $450, huh?
Thank you very, very much, NC Harley. If you're over 21, I can reward you ...
10-25-2006, 10:44 AM
#14
3rd Gear Member
Thread Starter
Join Date: Apr 2006
Location: Near Cape Cod, Mass.
Posts: 615
RE: I need a 5/32 tap
ORIGINAL: Colorado_Mustang
I feel left out here...
I feel left out here...
(Well it may only be in our dreams ...)
10-25-2006, 11:28 PM
#15
5th Gear Member
Join Date: Jun 2006
Location:
Posts: 4,089
RE: I need a 5/32 tap
Would take you a while to get here in the little sixer...especially this time of year. 
I hear the country side is fun to watch while cruising at 80mph. It's better at 100, though...especially Kansas.
I hear the country side is fun to watch while cruising at 80mph. It's better at 100, though...especially Kansas.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
yourmom6990
3.7L V6 Technical Discussions
2
10-14-2015 10:08 PM
