67fstback

im in the process of taking apart the interior of my 67 fast back, ive already got the entire dash, center consel, front seats off. i cant seem to figure out where to start to take off the back seats though. how do i go about doing this.
\
(oh and the reason why im taking apart the interior is beause my fastback was sitting in a garage for the last 10 years, and a family of rats decided to take over the interior, so everything needs to be replaced, and i dont want to be driving not knowing whats behind my dashboard or wherever, i.e. dead rats, rat dropping etc.)

middiepride

yeah, sounds like a good idea to me too

push the seat back then wiggle it up and it should eventually come off.

good luck

67fstback

there are no bolts or anything?

66GTKFB

Rats? Sell them to the 'bow-tie' guys.
The first step to get the rear seat out is to remove the four phillips head screws in the rear panel, two in the front with cup washers and two in the bumper cups. Be advised thatthere are four in the bumper cup and two of them are to hold the cup only. Lift the front of the panel and slide it forward. The rest is self-explantory - bolts for the folding section etc. Tape the shims on the folding section together and mark them RH and LH.
Jim