Proportioning valve, mounting locations?
#1
Proportioning valve, mounting locations?
I have recently installed a new brake power booster with new master cylinder, new lines, and new brakes. I have a new proportioning valve/dist. block that I need to install. The master cylinder has the outlet lines facing towards the passenger side. I was wanting to know if anyone has a good spot to mount this that is not going to interfere with anything. I know it should be somwhere next to the mc and I have the inner apron wall to mount to but any clever ideas will be appreciated. I don't want to have to move it if it is going to interefere with anything. The only thing I can think of that will be in thatarea is the hydraulic clutch that will be going in later.
#2
RE: Proportioning valve, mounting locations?
I just attached it to the inner fender near where the stock distribution block mounted, not really creative, but it allowed for short and somewhat attractivetubingruns from the M/C to the P/V.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM