Toastintx

Starting the assembly on my 65. I purchased the prebent SS brake and fuel lines. My question is does anyone have pict on how the lines are run?? I cant figure out how they are supposed to fit. also how do the brake lines attach to each other in the rear? the two that are coming from the brakes themselves and the line from the front. If any one has picts that would be very helpful
Thanks
Johnny

2+2GT

tx65coupe

Is your car a V8 or an I6? If its a V8 the fuel line is routed on the outside of the frame rail behind the front left wheel and then back into the engine bar from the side.

Toastintx

tx65 its a V8. do you mean it runs along the outside of the frame rail between the frame rail and the rocker panels.

tx65coupe

It runs on the outside of the front driver side frame rail under the upper A arm. There is a hole in the inner fender apron for it to come through a few inches up from the frame rail. Just behind the tire it goes under the frame rail and to to inside of the frame rail. In the mid section of the car it runs parrallel with the brake line up in the trans tunnel. It does not run near the rocker.

tx65coupe

http://www.allfordmustangs.com/forum...uel-line-2.jpg

http://www.allfordmustangs.com/forum...01-copy-2-.jpg

Toastintx

thanks tx65coupe that helps!