64.5 brake light switch after dual bowl conversion
#1
64.5 brake light switch after dual bowl conversion
I converted to a dual bowl master cylinder(used one from a 67), but now have no braske lights because there's no where to put the brake switch on the new master. As you may know was screwed into the old single master cylinder on the 64 1/2, and cars w/ dual master cylinder had a switch at the pedal, I think. Is there an inline adapter to re-use the old switch or can I make one? How?
#2
I converted to a dual bowl master cylinder(used one from a 67), but now have no braske lights because there's no where to put the brake switch on the new master. As you may know was screwed into the old single master cylinder on the 64 1/2, and cars w/ dual master cylinder had a switch at the pedal, I think. Is there an inline adapter to re-use the old switch or can I make one? How?
Thread
Thread Starter
Forum
Replies
Last Post
musnicki
Classic Mustang General Discussion
8
09-23-2015 07:11 AM
bond007
V6 (1994-2004) Mustangs
2
08-26-2015 11:36 PM