Finding an 8" 3rd member???
#11
I have been going crazy trying to put together a rear end. It is becoming more difficult than building my motor. I think one of the main reasons is because when i built the engine i was making cash. now i am just getting by. im not sure of the best way to go.
DAMN!
DAMN!
#12
I've seen a vendor on eBay that sells a complete 3rd member with trac-loc and your choice of gears already set up. IIRC it was $700-800 for the whole thing.
While that's a lot of $, I may get one of them when I get mine on the road. That way I can switch between my 2.79 open for highway use, then put the one with trac-loc and 3.89's for the street.
Of course, every plan I make usually changes 2-3 times before the time comes.....
While that's a lot of $, I may get one of them when I get mine on the road. That way I can switch between my 2.79 open for highway use, then put the one with trac-loc and 3.89's for the street.
Of course, every plan I make usually changes 2-3 times before the time comes.....
#13
Here is an Ebay dealer I will be using this winter
8" with "Posi" (yeah I know) limited slip
Choice of gear ratios and new bearings
1 year warranty
$559 plus shipping with exchange of your old one
http://motors.shop.ebay.com/jmmarket...1&_from=&_ipg=
Good Luck and Be Safe
Ron
8" with "Posi" (yeah I know) limited slip
Choice of gear ratios and new bearings
1 year warranty
$559 plus shipping with exchange of your old one
http://motors.shop.ebay.com/jmmarket...1&_from=&_ipg=
Good Luck and Be Safe
Ron
#17
They're relatively easy to rebuild, setting the crush sleeve was the biggest pain. I also got lucky when setting my backlash, only took me two adjustments to hit the sweet spot.
#19
Thread
Thread Starter
Forum
Replies
Last Post