Oh my God! How many times can I remove my tranny???
#11
Just a note on the weather...I'm with you here in CT. This has been a tough couple of weeks. I've never sweat so much in my garage....Its NUTS. I even tried working on it LATE at night....still too hot and humid. Next garage will have AC.
#12
I had mentioned in your other thread that you might have problems with that linkage using a diaphram clutch, sounds like it was a problem for the PO as well judging from what you found when you pulled it apart. I think the cable should solve that part of your problem. Has your T-5 been apart recently? Since it doesn't seem to vibrate without the tranny in place, but it's there with once you hook up the tranny it soulds like you might have a bad output shaft bearing causing that vibration, it's hard to be sure without actually hearing it myself, has it been getting progressively worse since you noticed it?
#14
I had mentioned in your other thread that you might have problems with that linkage using a diaphram clutch, sounds like it was a problem for the PO as well judging from what you found when you pulled it apart. I think the cable should solve that part of your problem. Has your T-5 been apart recently? Since it doesn't seem to vibrate without the tranny in place, but it's there with once you hook up the tranny it soulds like you might have a bad output shaft bearing causing that vibration, it's hard to be sure without actually hearing it myself, has it been getting progressively worse since you noticed it?
I took it out tonight and it's better than it was, but maybe because I buttoned it up with a Ron Morris trans crossmember instead of my modified one.
Thread
Thread Starter
Forum
Replies
Last Post
ShaneB26154
4.6L (1996-2004 Modular) Mustang
35
03-04-2021 04:05 AM
yourmom6990
3.7L V6 Technical Discussions
2
10-14-2015 10:08 PM
Greyshot
4.6L (1996-2004 Modular) Mustang
2
08-15-2015 03:32 AM