help with my distrubitor
#1
help with my distrubitor
my dissy got pulled out n not knowing one of my buddys cranked the car now timing compleatly off. need sum help getting the right timing on to get it to start..i have a 68 302 block with 1990 5.0 heads...can any one help
#4
You need to find Top Dead Center, aka, tdc. Manually turn the engine over until #1 cylinder is coming up on compression stroke. You can tell this when the spark plug is removed and your finger is covering the hole. Now start looking for the tdc mark on the balancer, the location where you'd point your timing light.
In your distributor, move the rotor to point to #1 wire. Be careful as you put the distributor in, as it will turn and you will no longer be pointing to #1. Just work with the turning thing. Once in, you'll be close enough to fire it up, then adjust your timing from there with the light.
In your distributor, move the rotor to point to #1 wire. Be careful as you put the distributor in, as it will turn and you will no longer be pointing to #1. Just work with the turning thing. Once in, you'll be close enough to fire it up, then adjust your timing from there with the light.
Thread
Thread Starter
Forum
Replies
Last Post