Inner rocker Q:
11-18-2011, 05:57 PM
3rd Gear Member
Join Date: Nov 2008
Location: cyprus
Posts: 518
We have a car lift at my bros house that we bought, might as well put it to use! I'm a bit of a perfectionist so I would prefer to weld bottom all the way through to have a nice tight seal! I don't like that gap sealer much.
11-19-2011, 08:46 AM
4th Gear Member
Join Date: Feb 2006
Posts: 1,001
Car lift will make it much easier - I'd go for it in that case. Welding on your back sucks
11-19-2011, 04:09 PM
3rd Gear Member
Join Date: Nov 2008
Location: cyprus
Posts: 518
Finished welding underneath today, tomorrow will grind down welds and prep for underseal!
11-19-2011, 04:20 PM
3rd Gear Member
Join Date: Nov 2008
Location: cyprus
Posts: 518
11-23-2011, 08:50 AM
4th Gear Member
Join Date: Feb 2006
Posts: 1,001
Looking good - I'm jealous - did full floor pan and rockers last year still sitting on jig and have not finished up welding floor in just because I dont want to get underneath to weld.
11-23-2011, 12:54 PM
3rd Gear Member
Join Date: Nov 2008
Location: cyprus
Posts: 518
You gotta go all out couple days and finish it! You can't do little by little and feel progress. That's what I think.
11-24-2011, 09:13 AM
3rd Gear Member
Join Date: Nov 2008
Location: cyprus
Posts: 518
Undersell down!!!
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Sixer4Life
V6 (1994-2004) Mustangs
5
10-12-2015 04:26 AM
69MustangCoupe393cid
Archive - Parts For Sale
2
10-03-2015 10:33 AM
uedlose
Archive - Parts For Sale
1
09-30-2015 08:01 AM
Sixer4Life
New Member Area
4
09-28-2015 07:05 AM
JDWalton
4.6L V8 Technical Discussions
8
09-24-2015 08:47 PM
1973,
65,
66,
convertible,
dynacorn,
fabricate,
fit,
ford,
forum,
install,
mustang,
panels,
replace,
rocker,
rockers 
