Tinmans Sub connectors mistake
#1
Tinmans Sub connectors mistake
I made a mistake that I can't undo but I will be okay, just a heads up.
I cut the end off the sub frame connector like required while the floor pans were out. What I did was cut the whole end off and the rail widened (sprung open a little at the top). After checking in again, he left part of the top of the end.
So, I think the support is there ans what little loss is structural support I lost I gained it back with the connectors. But I had marked ans welded the pans
So, a lesson learned.
I cut the end off the sub frame connector like required while the floor pans were out. What I did was cut the whole end off and the rail widened (sprung open a little at the top). After checking in again, he left part of the top of the end.
So, I think the support is there ans what little loss is structural support I lost I gained it back with the connectors. But I had marked ans welded the pans
So, a lesson learned.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
Seanam
V6 S197 General Discussion
5
10-04-2015 10:15 AM
TfcCDR
V6 (1994-2004) Mustangs
1
09-14-2015 12:08 PM