should i reuse this?-pedal support
#1
should i reuse this?-pedal support
so my brake pedal in my mustang was not returning on its on, and when i went to check it out, it was grinding on the column. so here is what i found last night when i tore it apart.
brake pedal side, do you think i should be reusing the stock pedal support?
brake pedal bushings
pivot shaft-dont think its supposed to have that groove in it.
This is the best that i could get the snap ring back in on the brake side, it does not seem fully seated in the groove, but its tight in there.
only part that i would like to replace that i dont have is the little plastic bushing on the clutch rod hole. besides that everything should be fresh. hope it make a difference in my pedal returning. Thanks
brake pedal side, do you think i should be reusing the stock pedal support?
brake pedal bushings
pivot shaft-dont think its supposed to have that groove in it.
This is the best that i could get the snap ring back in on the brake side, it does not seem fully seated in the groove, but its tight in there.
only part that i would like to replace that i dont have is the little plastic bushing on the clutch rod hole. besides that everything should be fresh. hope it make a difference in my pedal returning. Thanks
#3
You would have to weld that one to fix it. Its easy to do but if you dont have a welder or someone to do it might not be too easy to do. I would get the new rod they sell it with the roller bearings you must have gotten the kit without it. And yes this will help your pedal feel.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
0
10-01-2015 08:58 AM
Boostaddict
3.7L V6 S550 Tech 2015 - 2017
0
10-01-2015 08:57 AM
tj@steeda
Steeda Autosports
0
09-17-2015 07:57 PM
tj@steeda
Steeda Autosports
0
09-16-2015 07:53 PM
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM