Dash pad change on '65
#1
Dash pad change on '65
Been having a small problem with geting a new dash pad to fit on a '65. When I bought the car a few months back, it had a new dash pad already "installed" minus the trim pieces and mounting screws. Basically just pushed over the steel dash. I ordered all the mounting trim,screws,etc. but then discovered that the holes in the pad and dash won't line up on the bottom. Lacks about 1/4 inch or so. I then also noticed that the pad is actually for a '66 model, and don't know if this makes a difference. There is also a couple screws embedded in the front bottom of the pad that appear to have nothing on the metal part of the dash to attach to.
Any ideas...??
Any ideas...??
Thread
Thread Starter
Forum
Replies
Last Post
mungodrums
Suspension
0
09-07-2015 07:22 PM