T5 question
#1
T5 question
Hi, I jumped into the T5 conversion idea head first, and now that I'm learning more, I have some questions. I have a 65 mustang with a 1972 302 block. I just purchase a new WC t5 with a s10 tailpiece. I was told this was the way to go, especially if I wanted to use a hydraulic clutch. I have read this is pretty common, and the shifter location should be fine. The input shaft is a 025 from a 1985-1992 mustang. I went out an bought a 1994 bellhousing, which after doing a little research, I have learned will probably not work, because the input shafts got longer in 1994. Is this correct? Do I need a bellhousing from 1993 and under?
#3
I think since this was my first lost, I don't have PM capabilities yet. Can you send me the info about the bellhousing to my email address? Williams1370@yahoo.com. Also, the tailpiece from the s10 should work, correct?
#6
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
3
10-02-2015 08:06 AM
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM
treesloth
New Member Area
4
09-28-2015 07:03 AM