Classic Mustangs (Tech) Technical discussions about the Mustangs of yester-year.

Car won't Start

Thread Tools
 
Search this Thread
 
Old 10-27-2014, 07:27 AM
  #1  
brian31711
Thread Starter
 
brian31711's Avatar
 
Join Date: Oct 2014
Location: New York
Posts: 4
Default Car won't Start

I started my car to warm it up. It ran for about 10 min and then stalled out. I started it again and it stalled out after about 5 min. Now car won't start at all. Thought it was out if gas but that was not it. Tested fuel pump, changed plugs, changed starter solenoid, new ignition coil, tune up done about a month ago new plugs, wires, points, condenser, cap, rotor, new fuel sending unit new radiator. Tried starter fluid in carb still doesn't start. Any thoughts or possible solutions? Thanks in advance.
brian31711 is offline  
Old 10-27-2014, 08:05 AM
  #2  
bop11
2nd Gear Member
 
bop11's Avatar
 
Join Date: Apr 2014
Location: PA
Posts: 424
Default

If it won't start on starter fluid, ( you did not say if it fired but I assume not) it must be ignition or valves. Since it ran for 10 minutes, I think you can rule out valves. If you have a timing light, see if a plug is firing. It may be that the ignition switch has gone bad (intermittent) or that the resistor wire has burned out. Also check the neutral switch if automatic or the neutral switch jumper if manual. These can go bad but usually once started don't kill the engine.
Even though the points were just changed, the distributor plate threaded hole may be worn and you have lost your gap. An open capacitor /condenser will cause the points to pit quickly, but a shorted one will stop the engine.
If someone replaced the resistor wire, you could have a fried new coil or a cracked one. The timing light test will tell you this. While you have the light out check the static timing while cranking.
Last but unlikely, you could have jumped time. Was there blow back out of the carb when you tried the starting fluid?
bop11 is offline  
Old 10-28-2014, 06:40 PM
  #3  
brian31711
Thread Starter
 
brian31711's Avatar
 
Join Date: Oct 2014
Location: New York
Posts: 4
Default Thanks for the help

After going over everything again I decided to change the coil wire and the condenser. Bingo. Car starts up. It was the condenser. I just did a tune up about two months ago and replaced the condenser but I guess it was just bad. Thanks for the advice! Going to take it for a drive tomorrow and hopefully everything will be good. Thanks again.
brian31711 is offline  
Old 10-30-2014, 06:36 AM
  #4  
Adrenolin
5th Gear Member
 
Adrenolin's Avatar
 
Join Date: Aug 2007
Location: Delaware(US) & Nova Scotia(Canada)
Posts: 2,035
Default

Just finished an 1100 mile drive from Canada to Delaware last month in a new Classic addition, though not a stang. Arrived home, parked in the driveway and unloaded a few things. Neither of us felt like cooking for dinner so I jumped in the car to go grab a quick pizza. Click click click... Go figure! Turned out it was the ignition module in the HEI distributor and the module was only a month old. Quick trip to the parts store and 5 minutes later working fine. Funny how some things just go outta the blue. Glad you got it working!
Adrenolin is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
djbigskrilla
2005-2014 Mustangs
24
09-20-2022 01:04 AM
msavoia23
4.6L (1996-2004 Modular) Mustang
12
07-07-2018 12:08 PM
KEM Motorworks
5.0L (1979-1995) Mustang
20
08-14-2015 10:13 PM
92 5.0stang
5.0L (1979-1995) Mustang
4
08-13-2015 06:46 AM
Milan Dragway
Members Rides and Car Show Section
0
08-12-2015 03:43 PM



Quick Reply: Car won't Start



All times are GMT -5. The time now is 12:31 PM.