View Poll Results: Which cam would you vote for ?
JEGS Performance Products 200141
0
0%
Voters: 1. You may not vote on this poll
Best cam for 302 in my 68
#11
if your rockers dont have a long enough slot, you need new rockers . . you can buy just 1 stud.
#12
OH YEAH !
Got my rocker arms on and the broken stud replaced on the Mustang. I followed the directions of how they said to adjust the valves. But I didn't like how it sounded. So I did it old school method of running the engine and adjusting by sound....NOW IT SOUNDS FANTASTIC !
Saturday, will be putting the 3.55-1 posi-trac rear end and new speedometer gear in it. Currently it has a 3.00-1, so I think it will make a drastic change in the performance of it
Got my rocker arms on and the broken stud replaced on the Mustang. I followed the directions of how they said to adjust the valves. But I didn't like how it sounded. So I did it old school method of running the engine and adjusting by sound....NOW IT SOUNDS FANTASTIC !
Saturday, will be putting the 3.55-1 posi-trac rear end and new speedometer gear in it. Currently it has a 3.00-1, so I think it will make a drastic change in the performance of it
#14
Well I drove it home from work last night. Still have less than 800 miles on the car, engine and transmission. But I did floor board it when I was doing 40, and it picks up a lot faster than it did with the stock cam.
Will see how it runs tomorrow after I get the rear end in it.....
Will see how it runs tomorrow after I get the rear end in it.....
Thread
Thread Starter
Forum
Replies
Last Post
bradleyb
Classic Mustangs (Tech)
3
11-27-2015 07:50 PM