FS: trick flow twisted wedge and windsor jr heads
08-18-2009, 03:48 PM
#1
2nd Gear Member
Thread Starter
Join Date: Apr 2006
Location: The unemployment epicenter, Detroit, MI
Posts: 432
FS: Lightly Ported Windsor Jr. heads
I have a set of ported World Products Windsor Jrs. 1.94/1.60 Manley valves, dual springs good to .600" lift with solid or hydraulic, roller or flat tappet, mild port job, professional 3 angle valve job. Installed heights set(I forget height offhand, whatever World website specifies), and spring tension is 125# on the seat. ½" bolt holes for use on 302 or 351, 58cc chambers, have not been milled. Jegs sells these brand new with all the poor assembly quality World offers for $1,100. These are far better than that. $700 or best. Heads are completely assembled, painted, ready to go.
If interested, please email D1802 (at) sbcglobal (dot) net.
If interested, please email D1802 (at) sbcglobal (dot) net.
Last edited by Decurion; 11-02-2009 at 11:53 AM. Reason: Sold trick flows, updated wjr post
08-19-2009, 06:36 AM
#2
1st Gear Member
Join Date: May 2009
Location: Connecticut
Posts: 56
Are the trick flow heads iron or aluminum?
08-19-2009, 09:24 AM
#3
2nd Gear Member
Thread Starter
Join Date: Apr 2006
Location: The unemployment epicenter, Detroit, MI
Posts: 432
Aluminum.
08-19-2009, 05:36 PM
#4
Join Date: Aug 2009
Location: Ohio
Posts: 2
Hey care to do a trade? I have an Edelbrock plate system $589 new and the NY-TREX Triple threat threat $350 new. Let me know, Jared I know I'm new here but yu can check my rep on corral stangnet 3.8mustang all with same username.
08-20-2009, 08:24 AM
#5
2nd Gear Member
Join Date: Aug 2006
Location: NJ
Posts: 219
interested in the trick flow set, still got em?
08-22-2009, 07:57 PM
#6
2nd Gear Member
Thread Starter
Join Date: Apr 2006
Location: The unemployment epicenter, Detroit, MI
Posts: 432
EDIT: trick flows are sold
Last edited by Decurion; 11-02-2009 at 11:46 AM.
09-03-2009, 09:16 PM
#7
Join Date: Dec 2006
Posts: 7
Still got the TFS Twisted Wedge heads?? Anything wrong with them??
09-04-2009, 10:46 PM
#8
Join Date: Dec 2006
Posts: 7
Still interested...... Replied to your post for these heads on another forum also.
09-11-2009, 09:42 AM
#9
Join Date: Apr 2009
Location: Connecticut
Posts: 29
hey yu still got the trickflow heads......im interested in em....are they ready for direct bolt on????
