General Tech Ask model specific questions in the appropriate category below. All other general questions within.
Sponsored by:
Sponsored by: DashLynx

need ac help bad

Thread Tools
 
Search this Thread
 
Old 04-07-2014, 05:23 PM
  #1  
fordman+2
Thread Starter
 
fordman+2's Avatar
 
Join Date: Apr 2014
Location: virginia
Posts: 4
Default need ac help bad

New to forums. I have a 98v6 mustang. Ac was blowing hot air so I went to put Freon in it and when it wouldn't take I realized ac clutch wasn't engaging. Checked all fuses twice. Replaced ccrm. Still didn't work. Jumped high and low side and it still didn't work. Checked high and low side with test light and it was fine. Next I'm going to run a wire directly from battery to clutch. If clutch doesn't engage then its a clutch problem correct? Would really appreciate any help or suggestions.
fordman+2 is offline  
Old 04-07-2014, 05:37 PM
  #2  
Chromeshadow
3rd Gear Member
 
Chromeshadow's Avatar
 
Join Date: Apr 2011
Location: Wisconsin
Posts: 917
Default

Not sure how you hooked up the test light, but one side of the clutch should be ground, which should mean the test light will be off on that side (when the clutch is supposed to be on) Do you have a DMM or ohmmeter?
Chromeshadow is offline  
Old 04-07-2014, 05:57 PM
  #3  
fordman+2
Thread Starter
 
fordman+2's Avatar
 
Join Date: Apr 2014
Location: virginia
Posts: 4
Default

No I Don't have a DMM or ohmmeter. I had the test light grounded to the battery and it showed light on both sides. With car running and ac on wide open I tried to jump the high and low side and clutch still didn't engage.
fordman+2 is offline  
Old 04-07-2014, 06:40 PM
  #4  
AzPete
4th Gear Member
 
AzPete's Avatar
 
Join Date: Aug 2008
Location: Panama City, FL
Posts: 1,214
Default

If you have power to the clutch when all is on, then the other switching should be good.

I have used WD40 to clean the clutch magnetic contacts and gotten them to work. I just sprayed it while running. Be careful of the spray. If that does not work, then it sounds like it is time for a clutch.
AzPete is offline  
Old 04-07-2014, 07:10 PM
  #5  
fordman+2
Thread Starter
 
fordman+2's Avatar
 
Join Date: Apr 2014
Location: virginia
Posts: 4
Default

Thanks I'll give it a shot
fordman+2 is offline  
Old 04-08-2014, 06:59 AM
  #6  
Chromeshadow
3rd Gear Member
 
Chromeshadow's Avatar
 
Join Date: Apr 2011
Location: Wisconsin
Posts: 917
Default

I disagree about the electrical being ok, if you are certain that the light lit on both sides of the clutch, it means the switch on the ground side is not working. Can you try to ground that side? (I'd use a jumper with a 5A fuse-that way you will not burn up the wiring if you accidentally jump the hot side to ground). I don't remember the wiring on that year, but I think the pressure switch provides the ground path.
Chromeshadow is offline  
Old 04-16-2014, 06:08 PM
  #7  
rios239
 
rios239's Avatar
 
Join Date: Apr 2014
Location: florida
Posts: 7
Default

What i did when the clutch ddnt engage was to run cables from the ac compressor directly to the battery just to make shure the ac worked. After i saw the ac compressor worked, i then realized it was a blown fuse. So yes if u connect it directly and it doesnt engage then you can try to fix it or just get another ac compressor at a junk yard like i did, only $35.
rios239 is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Dathan
V6 (1994-2004) Mustangs
4
10-05-2015 05:52 AM
KingRando
2005-2014 Mustangs
5
10-02-2015 08:06 AM
ChampInSD
5.0L GT S550 Tech
13
10-02-2015 04:55 AM
UrS4
S197 Handling Section
1
09-30-2015 10:13 AM
GLOCKer
General Tech
0
09-28-2015 07:36 AM



Quick Reply: need ac help bad



All times are GMT -5. The time now is 06:26 AM.