XCalibrator 2 question
#1
XCalibrator 2 question
I'm the proud new owner of a Breenspeed XCalibrator 2. I thought that it could change the default setting on the traction control so that it would be in the off position when you turned on the car. But I'll be ****** if I can figure out how to do it. Is this possible?
#4
RE: XCalibrator 2 question
I think tuners are reluctant to do this because of the possible liability. In general, defeating "safety" features isn't a good long term corporate strategy. (Kid loses control of his stang on a wet road, runs over the nuns and children, plaintiff's lawyer goes after the tuner that turned off the TCS 'permanently').
There was actually a company that had a prototype of a relay/switch what would remember the on/off status of the TCS and keep it set there even when the car was turned off/on (e.g. if you turned off TCS it would stay that way until you pressed the dash button again). Never brought to market. I suspect for legal reasons because I think they could have sold a crapload of them.
There was actually a company that had a prototype of a relay/switch what would remember the on/off status of the TCS and keep it set there even when the car was turned off/on (e.g. if you turned off TCS it would stay that way until you pressed the dash button again). Never brought to market. I suspect for legal reasons because I think they could have sold a crapload of them.
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
3
10-02-2015 08:06 AM
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM
treesloth
New Member Area
4
09-28-2015 07:03 AM