lawrencecar1

This week i have a Roush polished M90 kit going in along with 2.57 pulley, JLT Big AIR CAI, Kenne Bell BAP and boost, fuel and a/f gauges. It's going to get dyno tuned for maximum safe hp. With the other mods already on i am anxious to see what the numbers will be .... More to follow..

TRexGAWD

Awesome.. post numbers once it's done.. I'm guessing around 390-400.. Maybe a little more, long tubes would help a lot more..

Soldier GT

Can't wait to see this one.. I agree with TRex.. high 3's low 4's for sure...

NJ3

I'm making 398 with my M90, Roush CAI and exhaust, so with a pulley and a JLT you should be around 425+.

lawrencecar1

With the FRPP cams, headers, x-pipe i am hoping for 450.

TRexGAWD

Hot rods?.. Ehhh, those aren't the best cams for a blower.. Sound good but wont make much more power than the stock cams with a blower.. 450 wheel will be pushing it but who knows.. Looking forward to it.

mighted1987

When i had hot rods, i lost a bit of torque and gained MINIMAL hp...but damn nice sound

xkape

Each car is different depending on the tune conditions. I have basically your setup (just different name brands) but no BAP or cams and I put out 417... I've seen people with just the M90, CAI, pulley kit and tune hit 430+.. who knows.

mighted1987

I put 350-_- mustang-dyno

908ssp

M90 is a waste of money. A Eaton m112 install cost less and makes 450rwhp on a super safe tune.