06 Mustang GT 470rwhp problems?
#12
Yeah it sucks. He post a thread over at s197forum.com Dropping a b326 motor from brenspeed into it.
Here ya go.
http://www.s197forum.com/forum/showthread.php?t=101598
Here ya go.
http://www.s197forum.com/forum/showthread.php?t=101598
#15
I'd love to know how much timing Timmbo had in is BBR tune? 440rwhp with 7lbs seems like a lot imo. I had a tune from another tuner that was hitting 22 degrees at 6k and I wasn't comfortable with that, but it did pull like a freight train. My brenspeed tune doesn't pass 19. he says it has meth injection, I assume that was on there when it blew. Was his blower intercooled?
Last edited by moosestang; 05-19-2013 at 08:12 AM.
#18
He has the m90 setup up, so yes there an intercooler. How do you find out the timing number in your tune? Did you just ask them?
If the motor goes out the bottom doesnt that usually mean the rods gave out? Detonation is usually out of the top?
If the motor goes out the bottom doesnt that usually mean the rods gave out? Detonation is usually out of the top?
#19
Detonation can cause the rod to fail, the piston to fail, bearing failures. I wanted to know if BBR bumped the timing to make good use of the meth. The computer will add or subtract timing based off other parameters like intake temps, but there's a max timing that it can't go over.
Last edited by moosestang; 05-19-2013 at 01:24 PM.
Thread
Thread Starter
Forum
Replies
Last Post
KEM Motorworks
5.0L (1979-1995) Mustang
20
08-14-2015 10:13 PM