New owner- clutch problem
#1
New owner- clutch problem
Hello all. I am the proud new owner of a 2004 Azure Blue mach. Car has 59k, BBK long tubes, OR X, magnaflow exhaust, cobra IRS with 4.10s, aluminum driveshaft, short shifter, SPEC stage 2 clutch kit, MM suspension, CAI, tune, and a set of black chrome fr500s.
If i drive the car normal, the clutch is perfectly fine. However, if i really get on it and shift at a high rpm, sometimes the clutch pedal will stick down to the floor. After a few second of not pushing the gas it will pop back up and catch. I wouldnt think the clutch would be going out, considering a stage 2 should be more than sufficient for my power levels. Is there anything else that could be causing this? The clutch seems to engage at the very top of the range of motion. So when you push it in, it feels real tight from starting, til about halfway down and then it just feels like nothing. I do have a firewall adjuster but have not attempted to mess with that yet. Any insight would be greatly appreciated, thanks!
If i drive the car normal, the clutch is perfectly fine. However, if i really get on it and shift at a high rpm, sometimes the clutch pedal will stick down to the floor. After a few second of not pushing the gas it will pop back up and catch. I wouldnt think the clutch would be going out, considering a stage 2 should be more than sufficient for my power levels. Is there anything else that could be causing this? The clutch seems to engage at the very top of the range of motion. So when you push it in, it feels real tight from starting, til about halfway down and then it just feels like nothing. I do have a firewall adjuster but have not attempted to mess with that yet. Any insight would be greatly appreciated, thanks!
Last edited by sjones1088; 07-30-2016 at 11:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Ayeecole
4.6L (1996-2004 Modular) Mustang
5
10-17-2022 07:37 PM
mohammadkhannj@gmail.com
General Tech
1
02-21-2016 03:01 PM