Ok I know its been asked 1000 times but I just picked up a great deal on an 05 V6 mustang. Its in great shape , its an auto but Im planning on swapping in a coyote I picked up with 5spd tranny that I had originally planned to fit into a cobra kit car I was building. I ended up selling the kit car as a roller and snagged this stang for $6000
So I plan on using the ford racing Control pack that comes with motor harness pcm , intake tube , air cleaner etc. I was hoping for some input from some guys who had dug into a s197 , I have heard that the engine cross-members are the same between V6 and GT, all Id need is coyote motor mounts?
Also I know the tach and speedo wont work with the tranny setup and new control pack , so I was planning on swapping out the cluster for a couple 5 inch speedo and tach and wiring them in , as well as misc other gauges Id creativily install. I have to figure out AC , Im assuming I could use a compressor from a coyote and get some lines made?
Also as far as fuel system goes , does the V6 run the same fuel pump as a GT? Im worried about the LPH or GPH if theres a difference. I need to research the Pressures and flow . Usually fuel injection mostly requires the same or similar PSI across the board. depending on app I assume. Any input is welcome.