Newbie
#1
Newbie
How do I post in the classifieds
My car is
1992 mustang lx 4 cyl swap to v8
Gutted dash
Fiberglass fenders and hood
Granatelli k member
Tokico front coil overs
Cage good for 8s
Upr anti roll bar
8.8 rear
Detroit tru trac locker
4:10 gears
moser axles
Dart 351 9.5 4.125 block 30 over
Cp Pistons 10.5 comp
Eagle crank and rods
Comp solid roller
Jesel rockers
Edelbrock Vic Jr. Manifold
Pro systems 950 cfm carb
Kooks stainless stepped headers
Pa trans rated for 1000 hp reverse pattern
Pa Sfi bell housing
Trans brake
Tci super street fighter with anti ballooning plate for nitrous
640 hp 628 tq on Dyno
Also set for an additional 150 nos
Edelbrock water pump
Fluidine radiator
Weld draglite wheels
Car is close to being done still need a few things
I have been building car for a long time about 10 12 years and it's been tuff
I had a couple people basically just take money from me
As the stuff they were supposed,to,do either didn't get done or was done poorly and had to be done again as you can imagine with stuff like that u run out of money quick
Then a bunch of time is spent saving more money
One engine builder actually wrecked my stock 351 block
It's been somewhat of a nightmare
And during winter I don't have a garage to use
And that cuts down on build time
I'm hopeing this spring I can finish
For the most part I still need fuel system parts
I have a a1000 areomotive pump
I need transmission lines
Some decent rear control arms
Have some brake work to finish braided lines and calipers and hard line work
Exhaust and mufflers
No tires yet either
Rear coil overs
Maybe with a little luck
My car is
1992 mustang lx 4 cyl swap to v8
Gutted dash
Fiberglass fenders and hood
Granatelli k member
Tokico front coil overs
Cage good for 8s
Upr anti roll bar
8.8 rear
Detroit tru trac locker
4:10 gears
moser axles
Dart 351 9.5 4.125 block 30 over
Cp Pistons 10.5 comp
Eagle crank and rods
Comp solid roller
Jesel rockers
Edelbrock Vic Jr. Manifold
Pro systems 950 cfm carb
Kooks stainless stepped headers
Pa trans rated for 1000 hp reverse pattern
Pa Sfi bell housing
Trans brake
Tci super street fighter with anti ballooning plate for nitrous
640 hp 628 tq on Dyno
Also set for an additional 150 nos
Edelbrock water pump
Fluidine radiator
Weld draglite wheels
Car is close to being done still need a few things
I have been building car for a long time about 10 12 years and it's been tuff
I had a couple people basically just take money from me
As the stuff they were supposed,to,do either didn't get done or was done poorly and had to be done again as you can imagine with stuff like that u run out of money quick
Then a bunch of time is spent saving more money
One engine builder actually wrecked my stock 351 block
It's been somewhat of a nightmare
And during winter I don't have a garage to use
And that cuts down on build time
I'm hopeing this spring I can finish
For the most part I still need fuel system parts
I have a a1000 areomotive pump
I need transmission lines
Some decent rear control arms
Have some brake work to finish braided lines and calipers and hard line work
Exhaust and mufflers
No tires yet either
Rear coil overs
Maybe with a little luck