619socalstang

here is the list:
bbk CAI fender well
Vortek 73mm MAF with MAF conversion and A9L puter
Profeinal Products polised upper and lower intake and 75mm tb and egr pl.
stock intake upper and lower with 65 mm tb and egr pl.
king cobra cluth 200 miles on it
center force gold used quite a bit but still holds better than the new king cobra
MSD Dis. for 87-93 5.0 roller ( never used still in box)
30# injectors
bbk regulator
ford Ecam and a Bcam
fully prep 306 block 1601 ford blue (Roller)
used 302 block (Roller)
used like new lifters (roller ford racing)
T5 very used but all gears work and does not slip out of any gaer
8.8 rearend limited slip is good spiders alitle worked
stock fuel tank and plumbing
rear seats and belts.

im not an expert on how to sell stuff over the internet but if you want something on the list send me a PM and will figure something out, i would really like to sell al the stuff to one person for cheap and let them split it up and make a few shells.

mustang13

what brand is the polished intake and what is included with the 306

1Bad302Stang

how much for the injectors and the e303 cam?

icepearl5.0

How much for the MSD Distributor, and the Mass air sensor?

619socalstang

professinal products (typhoon) same as an edelbroch

619socalstang

the injectors are accel and only have about 200 miles on them and same for the cam.

619socalstang

the dis. 230 brand new and mine is brand new and the maf is 230 and the electronics are 100.

Buzzstang

i am there man!

OneGearhead

how much would you want for the bbk cai fenderwell mount, the b cam, the used block and the 65mm tb and egr plate(if available w/o the intake, if not, send that too).

mytight95

umm how much for the intake by itself, and possibly the centerforce or king cobra as i need a clutch as well.


also where y ou located if semi-local could pick up



thanks


jason