Custom S197 Subwoofer box for single 12
#1
Custom Fiberglass S197 Subwoofer box for single 12
Category: Audio/Video/Electronics
Price: $250
Private or Vendor Listing: Private Listing
Part fits: S197
Location (State/Prov): TX
Item Condition: Used
This is an Audio Integrations Perfect Fit subwoofer enclosure for a 2005-2009 Mustang.
This box was $350 new without the subwoofer.
It tucks into the passenger corner of the trunk and fastens securely with 2 bolts, washers and rubber isolators.
It allows access to the spare tire. I am asking $200 for the box. $250 for the box and sub.
It is a Diamond Audio DVC 4 ohm sub that is easily wired to 2 ohms to an amp.
This is bulky I would prefer to sell in the Houston, TX area.
I had 400W RMS going to the sub and it sounds great.
EDIT: I UPLOADED HIGH RESOLUTION PHOTOS HERE
http://www.thedrod.com/forsale/sub
The following is copied and pasted from Audio Integrations Website---------------
Designed to save as much space possible, this Perfect Fit Enclosure™ sits on the passenger's side, still allowing access to the spare. Constructed out of hand laid fiberglass and perfectly sealed this enclosure will work well with almost any driver.
Enclosure Specifications:
Internal Airspace: 1.13-1.16 cubic feet
Mounting Hole Dia: 11 inches
Weight: 15 lbs.
Flush Trim Ring inside Dia: 11.25 inches
Examples of a few woofers known to fit: JL Audio W6v2, Alpine Type-r
Does not fit Sirius equipped vehicles without panel swap and Sirius relocation
Each Enclosure comes with: Flush trim ring wrapped in black vinyl, high quality terminal cup with the ability to accept up to 8 gauge speaker wire, 3 to 4 feet of 12 gauge Phoenix Gold speaker wire for inside the enclosure, pre-drilled hole for mounting, mounting hardware with instructions, stuffed with polyfill sound dampening for smoother bass response, and Audio Integrations Full Warranty (see link below for full warranty details).
No Drilling Required!! This Perfect Fit Enclosure™ mounts firmly to your Mustang with only one bolt! We do provide a second mounting bolt and hardware if so desired for an even more secure mount. Once bolted down with the included hardware, your enclosure won't be going anywhere no matter how crazy you drive! Using a factory hole in your trunk and our pre-drilled hole in the enclosure it makes for an easy and stealthy install. The mounting hole in the enclosure is standard unless otherwise requested. Please contact us before ordering if your needs differ. Instruction videoHere.
Your Enclosure comes standard wrapped in O.E.M. matching carpet, the vinyl flush trim ring comes in standard black.
Last edited by thedrod; 01-18-2012 at 06:27 PM.
#2
#3
#4
#6
#7
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
daltron
5.0L GT S550 Tech
17
04-28-2016 08:10 PM