GT500 Strut Mounts and Al. Driveshaft
#1
GT500 Strut Mounts and Al. Driveshaft
Category: Accessories
Price: $1
Private or Vendor Listing: Private Listing
Part fits: S197
Location (State/Prov): MD
Item Condition: Used
05-14 GT500 strut mounts are un-used and come in their original Ford Racing box. $85 shipped for the lower 48
http://www.americanmuscle.com/frpp-g...ount-0512.html
Shaftmaster's 1-piece aluminum driveshaft. This is the "3.5 inch Aluminum Driveshaft Ford Mustang 2005-2010 V8 GT Direct Bolt-In" unit. Had it on my 06 and shed 20 pounds and removed the notorious "thunk". $420 shipped, or will meet you if reasonably close to 21545
http://shaftmasters.com/3aldrfomu20v4.html
#3
Do you have the adapter plate that came with it? I do not see any pictures of it.
Last edited by sdonaghey; 08-24-2014 at 06:53 AM.
#4
I removed it because I sold my Mustang. Miles-wise, it has about 35k on it and I never had any issues. No dents or gouges, never hit
There is no adapter plate, it is direct bolt in. You attach the transmission end first and then line up the differential end. It will appear to be approximately an inch too short but that's because the slip yoke is relaxed. Literally pull on the driveshaft which will extend it the needed amount, bolt up, and your done.
It was my first mod, very simple.
There is no adapter plate, it is direct bolt in. You attach the transmission end first and then line up the differential end. It will appear to be approximately an inch too short but that's because the slip yoke is relaxed. Literally pull on the driveshaft which will extend it the needed amount, bolt up, and your done.
It was my first mod, very simple.
#5
#7
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM