nanaki

The shop called me and let me know good news and bad news about the install and tune. Good news is, i went from 360RWHP to 407RWHP. The bad news is the safety box for it is leaking. So whenever I actually go into boost and it kicks on, it's going to leak when I let off. I called snow performance and they're going to replace it. I'm going to pick my car up tomorrow. Can't wait!

luckythirteen13

47hp gain.....not bad at all. how much boost are you running and what is your total timing?

nanaki

not sure. they'll tell me tomorrow morning. i'm running 10psi. they have to show me where the leak is too.

luckythirteen13

what afr did they tune it to?

nanaki

i haven't seen the dyno print outs yet. told ya.. haven't even seen my car yet. i'll see everything tomorrow though.

luckythirteen13

fine!!!! make me learn patients[:@] lol

dajawu

I need an update!!!!

dajawu

Also did you just add the cooler, or did you pully down like you would with an IC. I am guessing with the meth you can't pully down cause you would be at to much boost for your stock block. Give me the info I am really thinking of going this route for obvious money reasons.

mlax

Hey nanaki were you there on Sat? (excessive) I finally got my S/C done! They whent with the next pully size down and I am running about 10#s of boost. The final numbers were 403rwhp and 392 rwtq.

nanaki

yeah, i was there. i got there around noon when they had some sick fox on the dyno. there was a malfunction with my boost cooler. i have to send a part back and get a new one. it was leaking a lot of fluid. it did put down 407RWHP though. when i get the part, they told me to come back and they'll put it on and put the more aggressive tune back on. should only take a sec since chris already spent a long *** time trying to tune it and already has it saved.