First dyno
#1
First dyno
Well, it's been almost a year since the build started. Car is almost done, just have to wait on Cervinis to paint the Cobra R hood I ordered. The pulls were done on a Dynocom dyno. The third run on a 14# pulley showed 403/408 rwhp/tq. Wasn't impressed...actually was kinda pissed, but hopefully the tuner was able to get it over 500 with an 18# pulley I gave him.
What's been done:
Kenne Bell 2.8LC kit
MMR 1000 HP kit standard bore (stock block)
Trickflow 2v heads
Stage 2 Comp Cams
Comp Cam beehive springs
60# injectors
Accel cops
BBK 300Lph fuel pump
BBK long tubes
BBK catted h pipe
Borla Stingers
3.73 gears
FRPP driveshaft
Have a Snow water/meth kit waiting to be installed. Tuner didn't want to touch it smh.
What's been done:
Kenne Bell 2.8LC kit
MMR 1000 HP kit standard bore (stock block)
Trickflow 2v heads
Stage 2 Comp Cams
Comp Cam beehive springs
60# injectors
Accel cops
BBK 300Lph fuel pump
BBK long tubes
BBK catted h pipe
Borla Stingers
3.73 gears
FRPP driveshaft
Have a Snow water/meth kit waiting to be installed. Tuner didn't want to touch it smh.
#3
#5
#6
Sounds like a plan! But with the numbers I saw from there, I doubt I'll see 600 from them. But I'll still line up against ya lol.
#7
Thread
Thread Starter
Forum
Replies
Last Post
Galactic
Archive - Mustangs For Sale
10
04-29-2019 02:56 PM
The01Cav
Maryland Regional Chapter
0
08-31-2015 04:12 PM