N/A to 04 terminator charger
#1
N/A to 04 terminator charger
Hey guys.. new to the Ford world so I was looking for some insight. I purchased a 99 cobra and have access to a stock 04 terminator charger. I was wondering if I can put this on my cobra and what other parts I would need to do this. Will the stock 04 intake bolt to my motor?
#4
Pretty extensive list of parts are needed. And I believe you will have to grind your knock sensor bosses down. Best bet IMO is to buy a complete eaton swap setup or you may end up getting nickel and dimed trying to buy each little piece separately. Essentially the timing cover, bulley bridge/pulley setup. Blower, lower intake and some misc wiring pigtails etc.
Thread
Thread Starter
Forum
Replies
Last Post
logan409
4.6L (1996-2004 Modular) Mustang
10
09-26-2015 07:43 PM