Blackout panels.

[mlcrycc]

Here's a pic of the 40 dollar one listed above, along with the taillight bezels. This one is supposed to be held on with 3M, but I applied magnetic tape over the 3M tape, and made it magnetic.... Mike

This ad is not displayed to registered or logged-in members. Register your free account today and become a member on Mustang Forums!

[windveilpete]

That's BEAUTIFUL. Where did you get the bezels?

[petepete]

ORIGINAL: mlcrycc

Here's a pic of the 40 dollar one listed above, along with the taillight bezels. This one is supposed to be held on with 3M, but I applied magnetic tape over the 3M tape, and made it magnetic....



Mike

Nice. so that is like a plastic or a vinyl becaus ei tlook sliek th evinyl one but you said its plastic. Just wanna make sure i know befor ei order. In any case i like the look i just hate trying to put vinyl on because i always get bubbbles >_< Also how thick is it if it is plastic?

[windveilpete]

That one is a plastic panel. I was asking about the bezels because i was worried about fit... whether or not the ebay plastic taillight bezels would make it too tight between the lights for the plastic piece.

I think that;s the route I am going to go with the plastic panel and the bezels... really nice and clean look.

[mlcrycc]

Thanks guys, appreciate the kudos....Both the blackout and the bezels are from Moss Mustang...

http://www.mossmustang.com/Shop/View...eIndexID=48645

http://www.mossmustang.com/Shop/View...eIndexID=48642

The panel is smoked plastic, not vinyl. It's about oh, an eighth of an inch or so thick. The bezels are made from the same material. Bezels are held on with 3M. I made the magnetic mod, since I want to be able to take the panel off for a different look, cleaning, etc. I also added 4 strips of velcro that wrap around into the trunk, for security sake, since doing just the magnetic tape was not enough for me. They both have a high gloss appearance, which is what I wanted....Matches the new spoiler and hood scoop that way....







Anything else you need to know, let me know.....

Mike

[petepete]

how are the tail light bezels installed? just stuck on or do you have to remove the tail lights?

[mlcrycc]

5 minute install....they just 3M on the outside of the tail light....

[petepete]

mmkay ordering then thanks for all your info

[mlcrycc]

My pleasure. Anything else, just shout.....

Mike

[rmays06]

Hey mike, how did you do it magnetic? just 3m tape and strips of magnet? Let me know, I'm putting one on this week. Got it from
http://store.cal-mustang.com/showdetl-7-9166-25-0.html
$51 shipped