Panhard length?
#1
Panhard length?
Can someone please tell me the length of the 05-11 'stang panhard bar center of bushing- to - center of bushing?
I am hoping someone has a stock unit laying around after lowering that they can put a tape measure to, or maybe an adjustable unit they haven't installed yet.
I have searched the forum ,but couldn't find any exact measurement.
-Brad
I am hoping someone has a stock unit laying around after lowering that they can put a tape measure to, or maybe an adjustable unit they haven't installed yet.
I have searched the forum ,but couldn't find any exact measurement.
-Brad
#4
OP, I'll measure mine for you later this evening to get you a rough idea. However, I did cut my stock panhard bar in half out of boredom one evening, so it wont be an exact measurement, be off by a few MM to account for the thickness of the saw blade.
#5
PHB Lengths
Good point. I guess that most "standard" Mustangs will have a common length.
However, I recently put Vogtland springs in mine and the body moved to the left (drivers side) at least 1/2", and I'm not as low as the Shelbys or Bullitts. Gotta be more than one length from the factory.
However, I recently put Vogtland springs in mine and the body moved to the left (drivers side) at least 1/2", and I'm not as low as the Shelbys or Bullitts. Gotta be more than one length from the factory.
Thread
Thread Starter
Forum
Replies
Last Post
junior04
4.6L (1996-2004 Modular) Mustang
1
09-28-2015 10:53 AM